How to Hit a Low Draw With Your Driver Set up to hit a straight drive. This is the easiest way to learn how to adjust your setup to hit the low draw . Adjust your ball position. Pull your right foot straight back 2 or 3 inches from the target line. Keep your shoulders parallel to the line of your feet. Make your swing.
Draw -bias designs also encourage a straighter ball flight by featuring higher lofts, lighter shafts and more upright lie angles. There’s even evidence that with the CG closer to the heel, draw drivers help average golfers return the face to square at impact because the CG is closer to the shaft.
Left Foot Back Just before starting the swing, players can draw back the left foot. This alteration in the stance will cause the body to aim well left of the target and force the swing path more in-to-out. To hit a draw shot, left handed golfers will be forced to release the club (cross the forearms) through impact.
“Provided the ball speed, launch angle and spin rate are the same, a draw and fade will carry and roll the same distance. However, from a practical perspective, most club golfers will hit a draw further than a fade , because when they hit a draw they reduce the loft, leading to lower spin rates.
Because the swing is an arc, the clubhead actually moves toward the right during the downswing. If you place the ball too far back in your stance, you can contact the ball when the club is still headed right .
The typical golfer who slices the ball will have too much forward lateral bend, this causes them to stay on top of the golf ball for longer, not effectively turning into the ball and eventually leading to a slice across the ball, which might lead to pulls, slices or even shanks.
You will want to think about swinging the path down the line and trying to get the ball to start somewhat straight. I like to hit a slight right to left path even with an open stance . This allows me to hit a draw or even a push fade. Lee Trevino hit some of the great push fades as well as Jack Nicklaus.
Except when he was working on a flat-plane fade . And through all this, he still maintains that his natural shot is a slight draw . These days, he appears to be going with a flattish, single-plane swing that allows him to fade his driver, draw his 3 wood, and work the ball around with his irons.
You might have been told to sweep the ball off the tee with your driver to maximize distance. But if you frequently hit slices or pulls, this swing thought will likely make your problems go from bad to worse. To cure your slices and pulls, hit down on the ball with your driver .